Documenting my Failures (and ultimate Success) with the Prusa Printer

As many of you know from my previous post, I left off discussing the misalignment of my Pinda Probe over the print bed. I wasn’t sure how big of an issue it was going to be, until I tried calibrating the XYZ axis. The nozzle began hitting the bed after the 3rd pinda position and I had to abort the calibration. I was pretty confused how to fix this problem and began digging around Prusa’s support site and different blogs/websites dedicated to Prusa printers. The most useful site I found was the Pinda misaligned page on the Prusa site. I determined my issue was shown in this diagram:


My Pinda had managed to front shift during the repairs of my extruder (see the post below for a rant of that godforsaken clog). The page said that to fix this problem, “just unscrew the M12 bolts holding it, move the Z-frame back (or front, depending of the position of the pinda relative to the heatbed probe circles, and tighten it back”.

Well, “just unscrewing the M12 bolts” turned out to be more difficult than I imagined. First of all, I didn’t put together the printer (yes, I’m one of those people who bought it pre-assembled) so I wasn’t quite sure where the M12s were located. I finally found this video by Josef Prusa which shows the exact location under the printer (around minute 8:00).



After finding the bolts, I discovered that I probably needed to work out a bit more, as I could not loosen them. Even my boyfriend struggled and we sat for a while baffled at how we would possibly loosen them. FINALLY, with some help of WD-40, we were able to undo them. I realigned the Pinda within the circle and tightened the blots…. to only realize my Z frame was skewed. It took a couple tries, but I finally got it to sit perpendicular. Overall, it was a bit of a process, but the printer ended up calibrating fine (I’m still getting “XYZ¬†calibration all right. X/Y axes are slightly skewed”, but that’s a fix for another day).

Here’s a pic of a quick test print, which I’m quite pleased with:


I’ll post some more photos later of future prints, but in the mean time, happy printing!


Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s